HIGHS CAN-BUS RESISTOR 1107933

Name: HIGHS CAN-BUS RESISTOR
SKU: 1107933

Kód: 1107933

Cena: Cena na dotaz

Popis produktu

HIGHSIDER smart CAN-BUS resistor CBW1 with DIP-switch.
Our newly developed HIGHSIDER smart CAN-BUS resistor CBW1 fits most vehicles that have a CAN-BUS system.
The CBW1 resistor provides a required electrical load for your vehicle, which, if the dip switches are set correctly, will result in no flashing of the accessory flashers in the cockpit.
In addition, a reliability is given. This means: If the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit.
Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right.
If 2 pairs of indicators need to be changed,also 2 CBW1 needed to be used.
Which requirements should be met in order to use the CBW1 on the motorbike:
The motorbike was originally produced with LED indicators or the motorbike has a CAN-BUS System
If these requirements are not met, the CBW1 unit will not function (!) In this case, we recommend the following resistances:
For indicators with 21 Watt: 6,8 Ohm partnumber 1108546002 or 10 Ohm partnumber 1108546004
For indicators with 10 Watt: 27 Ohm partnumber 1107562
The following resistance values can be set on the CBW1:
<ul>
<li>150 ohms</li>
<li>170 ohms</li>
<li>240 ohms</li>
<li>300 ohms</li>
<li>400 ohms</li>
<li>600 ohms</li>
<li>1200 ohms</li>
</ul>
Dimensions: Height = 11mm Width = 31mm (without straps) Width = 46mm (with tabs) Length = 40mm
Cable length = 200mm with pins
Connections: Yellow = input channel 1 (+) Orange = output channel 1 (+) Blue = input channel 2 (+) Red = output channel 2 (+) Gray = input mass (-) Black = output ground (-)
Hints: – Up to 2 channels can be operated. – The connection is explained precisely in the mounting instructions!