RFX PRO THROTTLE TUBE, BLK 1128804

Popis produktu

<p>RFX Pro Series Throttle Tubes are machined from billet aluminium and feature a sealed bearing and Teflon sleeve to provide an effortless throttle action. RFX Pro Series Tubes resist damage in a crash unlike standard plastic tubes. For these reasons they are used by many of the top race teams and riders in the U.K Championships such as STR KTM.</p>
<ul>
<li>Replacement throttle tubes for all popular off road bikes.</li>
<li>Uses the same cam profile as the OEM part for proper throttle control.</li>
<li>Hard anodised billet aluminium construction.</li>
<li>Sealed ball bearing and Teflon sleeve virtually eliminate friction.</li>
<li>Laser etched with RFX logo.</li>
<li>Knurled grip mounted area.</li>
<li>Reduced chance of damage if you crash.</li>
</ul>
<p><strong>Roller Bearing&nbsp;</strong>for an effortless throttle action</p>
<p><strong>CNC Machined Construction&nbsp;</strong>for the ultimate crash resistance</p>
<p><strong>Fitting Instructions:</strong></p>
<ul>
<li>Slide the rubber boot down and disassemble the throttle housing, remove the old throttle tube taking care not to damage the throttle cables.</li>
<li>Carefully remove grip from the old throttle tube if required.</li>
<li>Inspect the cables and housing for excess damage or wear, clean and lube them or replace if required.</li>
<li>Clean the handlebar and inspect for damage where the old throttle tube has been spinning on the bar if a ridge is present replace the handlebars.</li>
<li>Slide the new throttle tube on the handlebar and lube using a penetrating lubricant preferably Maxima MPPL (do not use grease as this attracts dirt and makes the throttle stick after a short period of time).</li>
<li>Re-assemble the throttle cables and housing again using some penetrating lubricant.</li>
<li>Tighten the throttle housing in the correct position on the handlebars.</li>
<li>Adjust the cable to the required (free play amount) of your liking.</li>
<li>Rotate the handlebars to their maximum position to check proper operation of the throttle and correct cable routing, some re-adjustment of the cable may be required.</li>
<li>Slide the rubber boot back over the housing.</li>
<li>Cover the hole in the end of the grip with some electrical tape (To stop glue entering the throttle barrel) and apply a small amount of RFX grip glue to the outer end of the throttle tube on the outside diameter.</li>
<li>Apply a small amount of RFX grip glue to the inside of the new grip and slide onto the tube.</li>
<li>Twist the grip to the correct position and leave to dry.</li>
<li>Apply RFX safety grip wire if needed.</li>
<li>After the glue has dried again check proper operation of the throttle. </li>
</ul>